How to set a SpeedStream 4200 to modem bridged mode

Resetting modem to Factory Defaults

Using the tip of a ballpoint pen or unfolded paperclip, press and hold the Reset button located on the bottom of the router. The pwr LED will blink red once, indicating that the reset has begun.

Continue depressing the Reset button for four seconds or until the pwr LED begins to blink alternating red-to-green.

Release the Reset button.

Set to bridged mode

Should now be on http:\\10.0.0.138

Click “Login” option. The “Username” is admin and the “Password” is admin. Then click “OK”.

Click the “Setup” option and then click the “WAN interface” option.

If asked for a Username/Password use admin/admin

Click under VC heading the “8/35” option.

Click “Next>>”

The PPPoE option should be selected and then click “Next>>” again.

Under the heading “PPPoE Type” select the “Bridge only” option and then click “Next>>”.

Click “Finish”

A reboot is required before the new configuration takes effect. Click the word “reboot”. An additional “Reboot” button will be displayed. Click this “Reboot” button”

Leave a Reply